peer node

The peer node command allows an administrator to start a peer node, reset all channels in a peer to the genesis block, or rollback a channel to a given block number.

Syntax

The peer node command has the following subcommands:

  • start
  • reset
  • rollback

peer node start

Starts a node that interacts with the network.

Usage:
  peer node start [flags]

Flags:
  -h, --help                help for start
      --peer-chaincodedev   start peer in chaincode development mode

peer node reset

Resets all channels to the genesis block. When the command is executed, the peer must be offline. When the peer starts after the reset, it will receive blocks starting with block number one from an orderer or another peer to rebuild the block store and state database.

Usage:
  peer node reset [flags]

Flags:
  -h, --help   help for reset

peer node rollback

Rolls back a channel to a specified block number. When the command is executed, the peer must be offline. When the peer starts after the rollback, it will receive blocks, which got removed during the rollback, from an orderer or another peer to rebuild the block store and state database.

Usage:
  peer node rollback [flags]

Flags:
  -b, --blockNumber uint   Block number to which the channel needs to be rolled back to.
  -c, --channelID string   Channel to rollback.
  -h, --help               help for rollback

Example Usage

peer node start example

The following command:

peer node start --peer-chaincodedev

starts a peer node in chaincode development mode. Normally chaincode containers are started and maintained by peer. However in chaincode development mode, chaincode is built and started by the user. This mode is useful during chaincode development phase for iterative development. See more information on development mode in the chaincode tutorial.

peer node reset example

peer node reset

resets all channels in the peer to the genesis block, i.e., the first block in the channel. The command also records the pre-reset height of each channel in the file system. Note that the peer process should be stopped while executing this command. If the peer process is running, this command detects that and returns an error instead of performing the reset. When the peer is started after performing the reset, the peer will fetch the blocks for each channel which were removed by the reset command (either from other peers or orderers) and commit the blocks up to the pre-reset height. Until all channels reach the pre-reset height, the peer will not endorse any transactions.

peer node rollback example

The following command:

peer node rollback -c ch1 -b 150

rolls back the channel ch1 to block number 150. The command also records the pre-rolled back height of channel ch1 in the file system. Note that the peer should be stopped while executing this command. If the peer process is running, this command detects that and returns an error instead of performing the rollback. When the peer is started after performing the rollback, the peer will fetch the blocks for channel ch1 which were removed by the rollback command (either from other peers or orderers) and commit the blocks up to the pre-rolled back height. Until the channel ch1 reaches the pre-rolled back height, the peer will not endorse any transaction for any channel.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.